Show Low Electrical FAQ

A burning smell from an outlet or the panel, sparks, an outlet hot to the touch, a breaker or main that trips the moment it is reset, partial power loss, buzzing from the panel, or water reaching wiring. If there is smoke or flame, leave the house and call 911 first. For a downed power line, stay away and call your utility. More on this: Common electrical problems in Show Low.

Not always. A Level 2 charger needs a dedicated 240-volt circuit, and a load calculation shows whether your panel can carry it. Many older and manufactured homes have a 100-amp service with little room to spare; options include a smaller circuit, a load-management device or a 200-amp upgrade. We will ensure that your EV charger installation in Show Low is handled by professionals.

One flickering bulb is usually the bulb, a loose bulb or a worn switch, or an LED bulb on a dimmer that does not match it. Flickering in several rooms, especially when a large appliance starts, can mean a loose connection in the panel or at the service, or a failing neutral. That needs an electrician soon. We are committed to making flickering light repair in Show Low simple and reliable.

It can be. Homes wired between 1965 and 1973 may have solid aluminum branch circuits, and the Consumer Product Safety Commission found their connections are far more likely to reach fire-hazard conditions than copper ones. The risk is at outlets, switches and splices, and approved connectors or rewiring address it. See Why your breaker keeps tripping for related warning signs.

Panel changes, new circuits, EV chargers, generators and similar work go through a permit and inspection. Inside city limits that is the City of Show Low, which applies the 2017 National Electrical Code; outside them, Navajo County, and in Pinetop-Lakeside, Snowflake and Taylor, the town or county as required. Our team is fully committed to permitted, inspected electrical work in Show Low.

Any Arizona contractor's licence can be looked up for free on the Arizona Registrar of Contractors website, roc.az.gov, by business name, licence number or the qualifying party's name, and asking about it is normal and expected. The lookup shows status, classification, bond and complaint history. We believe that transparency is part of reliable service.

The work on site is commonly most of a day, because the power has to be off while the old panel comes out and the new one goes in. Scheduling adds time on either side: the permit, the utility disconnect and reconnect, and the inspection. Our team coordinates each step so the job is completed properly. See Electrical safety checklist for what to check meanwhile.

If something is hot, sparking or smells burned, switch off that breaker if it is safe to do so. Clear the area in front of the panel and around the problem outlet or fixture, keep pets out of the way, and note when the problem started and what was running at the time.

Yes. Our team serves all three; see the service areas page. Pinetop-Lakeside is about ten miles southeast of Show Low on State Route 260, and Taylor and Snowflake lie about sixteen and twenty miles north on State Route 77. Outside those towns, call and ask.

Call (928) 251-2924 today and describe the problem and where you are; same-day visits are often possible when an electrician is available. If there is smoke or flame, call 911 first. Our team is committed to reliable electrical repair across Show Low, and every job is handled by professionals.